How Much Does It Cost to Replace a Faucet Cartridge? [2026]

The cost to replace a faucet cartridge is one of the cheapest repairs in the house: Angi puts the cartridge itself at $10 to $100, and a plumber’s leaky-faucet repair at $100 to $400, averaging $270. This page is for the homeowner standing at a dripping sink or a shower handle that won’t fully shut off, trying to decide whether to grab a cartridge puller or make a call. The honest answer turns on one thing more than any other: whether you can positively identify the cartridge and whether it comes out cleanly.

For how this compares against other common repairs, see our data study on what plumbing repairs cost, DIY vs. a pro.

How Much Does It Cost to Replace a Faucet Cartridge?

For a straightforward sink faucet, DIY cartridge replacement costs the cartridge, $10 to $100 (Angi), plus a special tool if the cartridge is difficult to remove (Home Depot). Hiring it out costs $100 to $400, with Angi’s national average landing near $270 for a leaky-faucet repair (Angi).

These are ranges, not quotes — the number you actually pay depends on the brand, whether the cartridge is seized, and whether you already own the tools. To estimate your specific job, use our free Plumbing Repair Cost Estimator.

What Drives the Cost (the Honest Spread)

The cartridge itself is cheap; getting it out cleanly is what costs money. Home Depot rates cartridge replacement as an intermediate job doable in under two hours when the faucet comes apart normally, and This Old House puts many kitchen faucet repairs at 20 to 30 minutes (Home Depot, This Old House). But hard water changes that math: USGS notes that hard water leaves scale buildup in pipes, and Moen recommends cleaning and flushing the valve body before a new cartridge goes in, because debris could damage the new cartridge or block the flow of water (USGS, Moen). Moen even publishes a separate procedure just for stuck 1200/1225 cartridges, and plumbing-forum threads describe scratched or gouged valve bodies after a bad removal attempt turning a $20 part into a valve-body replacement (Moen, Terry Love forum). Cartridge type matters too: Home Depot lists a Moen 1225B sink cartridge at about $30 and a Moen 1222 pressure-balance cartridge at about $72 (October 2026). Whichever type it is, a plumber’s bill is dominated by labor, not parts: Angi lists plumber labor at $45-$200 per hour, and a fast cartridge swap can still trigger a minimum charge or trip fee that makes a 20-minute job price out like a full service call (Angi).

Repair vs. Replace — the Honest Math

Start with the cartridge, not the whole faucet. If the fixture is under about 15 years old, this is the first leak, and the shutoff valves work, replacing the cartridge, a $10-$100 part, is almost always the right first move — Angi puts typical bathroom faucet life at 15 to 20 years and recommends replacement mainly when a faucet is near that age or already has repeated repairs, corrosion, or persistent leaks, not after a single cartridge failure (Angi, Angi repair-vs-replace). Full faucet replacement makes more sense when the cartridge failure is one symptom among several — stiff handles, corrosion, worn mounting hardware, or a finish that’s seen better days. At that point the math shifts: HomeAdvisor puts a kitchen faucet replacement at $162 to $364, averaging $262, starting as low as $91 for a basic faucet with a partial DIY install. If the faucet is otherwise sound, a $15-$30 cartridge beats a $99+ replacement every time; once the faucet is old and failing in more than one way, the replacement cost buys you a clean reset instead of a second repair bill.

Should You DIY It or Hire a Pro?

The honest savings is almost entirely labor. A DIY cartridge job costs the part ($10-$100) plus maybe a $6-$26 puller tool, against a $100-$400 pro visit — call it $90 to $270 saved, which is why Home Depot rates this as an accessible intermediate project and Kohler says installing new valves in a two-handle faucet is something almost anyone can do (Home Depot, Kohler). That savings only holds when three things are true: the shutoff valves actually work, the cartridge is correctly identified before the faucet is disabled, and the cartridge isn’t seized. Skip any of those checks and the math flips — Angi’s broader DIY survey found more than 40% of homeowners rated their DIY projects more expensive than expected, more than 40% found them more challenging than expected, and nearly 80% made at least a minor mistake along the way (Angi Inc.).

Before you buy, find your exact cartridge with our free Repair Finder so you don’t make a second trip to the hardware store.

When to Call a Pro

This is the section that actually decides the cost. Call a plumber when:

• The cartridge is seized or won’t budge with reasonable force — Moen publishes a separate procedure for removing a stuck cartridge Moen.
• The shutoff valves under the sink (or behind the wall) are unreliable, frozen, or missing — you need working shutoffs before you can safely open the valve body Home Depot.
• The faucet is a tub/shower valve buried behind a wall rather than an accessible sink faucet — the repair scope and risk both go up.
• You can’t confidently identify the brand or model, and the faucet is old enough that a mismatched part means a second trip or a damaged valve body.
• You live in a condo or multi-unit building where the individual shutoff may not isolate the work — a failed shutoff there can affect other units, and shared-plumbing water damage crosses unit boundaries.

DIY is reasonable when the faucet is accessible, the shutoffs work, the part is identified, and you can give it up to two hours: Home Depot rates cartridge replacement an intermediate job doable in under two hours. Past that line, the $90-$270 you’d save on labor is smaller than the cost of a mistake.

A few scenarios flip the usual advice. In a rental or multi-family unit, a pro visit often beats repeated DIY attempts once you count tenant downtime and repeat-call risk — Delta’s warranty itself treats multi-family and commercial use differently from an owner-occupied home, at 10 years and 5 years respectively instead of a lifetime Delta. In a historic or character-defining bathroom, the National Park Service’s restoration standards favor repairing and retaining the original fixture over replacing it, which argues for a careful pro cartridge or valve rebuild rather than a swap NPS. And if you’re selling soon, a documented cartridge repair is usually enough on an otherwise attractive, newer faucet; a dripping faucet near 15 years old is another matter, since that is the age at which Angi suggests replacing one.

How to Choose and Vet a Plumber

If the job is past the DIY line, a few minutes of vetting saves money. Describe the problem precisely — “single-handle kitchen faucet, dripping at the spout, I think it’s the cartridge” — so the quote reflects the actual job instead of a worst-case guess. Ask whether the quote already assumes the cartridge is stuck, since that’s the variable that moves the price from the $100 low end toward the $400 high end. Confirm the plumber is licensed and insured, and get the price in writing before work starts. A like-for-like cartridge swap in the same location typically doesn’t need a permit, but HomeAdvisor notes that moving a fixture or adding a new line can trigger a $50-$500 permit cost, so ask if the scope has grown beyond a simple swap HomeAdvisor. For a job this size, two or three quotes is reasonable — a wide spread usually means one plumber is pricing in a stuck cartridge or valve-body risk that another isn’t.

If you’d rather confirm the cause before you call anyone, our Complete Guide to Faucet Repair and Why Is My Faucet Leaking cover the diagnostic step, and How to Identify Faucet Brand and Model plus our brand-specific guides for Moen, Kohler, Delta, and American Standard cartridges walk through identification in full. If you’ve already confirmed a Moen 1225 cartridge is the fix, our step-by-step replacement guide covers the DIY procedure end to end.

Sources

• Angi – Plumber Cost to Fix a Leaky Faucet
• Angi – How Long Do Bathroom Faucets Last
• Angi – Should I Repair or Replace a Leaky Faucet
• Angi Inc. – Risks and Rewards of DIY
• HomeAdvisor – Cost to Install a Faucet
• HomeAdvisor – Who to Hire for Faucet Replacement
• Home Depot – How to Replace a Cartridge in a Faucet
• This Old House – How to Repair a Leaky Faucet
• Moen – Removing a Stuck 1200 or 1225 Cartridge
• Moen – Valve Body Cleaning and Flushing
• Delta – Faucet Warranty
• USGS – Water Hardness
• National Park Service – Restoration Treatment Standards

Educational content only. Not a substitute for licensed professional advice. Local plumbing codes vary by jurisdiction. Use of any guidance from this guide is at your own risk.